<< Click to Display Table of Contents >> Navigation:  Modules > Workflow Automation > Workflows > Graphical Workflow Designer > Workflow Window > Creating Links

Creating links is done entirely with the mouse by following these steps:

 

1.Hover the mouse over the desired beginning port (Next, True/Yes, False, Timeout, Err 1, Err 2, Err 3, or Err 4).  The cursor will change to a 'pointing finger' if the port is a valid starting point.  Each of these output ports will allow one link.

2.Left click and hold down the button.

3.Drag the arrow end of the link to the desired target PP node.  The arrow will snap to valid input ports as it gets close.

4.Release the left button when the link has snapped to the desired port on the target PP node.

5.To cancel creating a link, simply release the left button while the link is not connected to a valid port.  The link simply goes away.